Temperature and Air Solutions: Heating and air conditioning Maintenance for Homeowners

Your water heater is one of the most used and much more costly appliances in your home, and consumes a large associated with your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving with regards to your home heating and costs.

Regular flushing of your water heater is probably the single most important step you get to prolong its service life additionally, you will save energy. Over a period of time, sediments strengthen in the bottom of your water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. In part destructive to the tank, but highly inefficient and will significantly raise your heating costs.

In most areas of the country, the average water heater lasts 3-5 years. Regularly flushing your hot water heater can double living of your water heater from 3-5 to 7-10 years. To provide a source costs of replacement running from $700 to over $1200 in some cases, getting the most from your heater is critical in today’s affordable. In addition, regular flushing makes your water heater run more efficiently and can cut heating costs fifty percent. Depending on the volume of drinking water your home uses, that can mean a savings of $20 to over $50 a week.

To drain your water heater, first you should set the thermostat to pilot (if it is a gas water heater) or turn the circuit breaker off (if it is actually electric heater). Failure to do so could result in overheating and severe damage to water heater. Next, close the water supply valve located on a water inlet line going into your water heater. Equipped to connect a garden hose to the drain valve located towards the end of the heater tank. Open the drain and allow it working out until all on the water has emptied from the air conditioner. Then close the drain. Open the water supply valve and refill the heater. You should also open a hot water faucet somewhere inside and stand there and watch it run for several minutes until the actual flows out quietly. This will allow air to vent off of the heater and the water lines. Finally, you can turn the thermostat to be able to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).

Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system home to filter or condition the water so it is less corrosive to your plumbing system, particularly in areas possess hard stream. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in location to discuss options and merchandise to suit your needs.

Abacus Plumbing, Air Conditioning & Electrical

The Woodlands, TX

(281) 528-1610

https://goo.gl/maps/Fccz1JjKrjN2